Ceramic fibreboard is aluminum silicate fibreboard, a kind of refractory materials produced by the board.Even after heating to maintain good mechanical strength, the product is more rigid than fiber blankets, blankets and support strength fiber insulation products.In recent years, the use of ceramic fibreboard is more and more widely, and then zhongsteel refractory factory for you to illustrate the ceramic fibreboard in different industries installation methods what are the differences!

· Decoration industry

Ceramic fiber products can be installed by metallic or ceramic anchor studs and washers either exposed to hot face or conceal in ceramic fibers. Ceramic fiber products also can be installed by cement bonding method.

Ceramic fiber

Industrial furnaces

1. Clean the surface of the construction site (including the surface of ceramic fiber board).

2. Binder ratio: bond powder and water glass are evenly mixed according to 1:1.2 (not to use water).

3. Apply the binder evenly on the surface of the heat insulation board with a plastering tool, and make sure that the products are bonded tightly between the upper and lower parts.

Processing industry and heat treatment industry

1. Clean the floating ash, oil and other debris and empty drum parts left on the concrete wall.

2. Remove the concrete blocks, inclusions and empty drums of the split roof, and repair them again.

3. It is required to paste ceramic fiber board with surface roughness deviation of not more than 4mm, polish the protruding concrete surface and make up the concave part when the deviation is out of tolerance (use 1:2.5 cement mortar plastering when the thickness is more than 6mm, and use polymer-bonded mortar when the thickness is less than 6mm to make up);To ensure the flatness of the whole wall is within 4mm, the square Angle of Yin and Yang, smooth up and down.

4, the construction of mortar is divided into binding mortar and surface with high temperature adhesive.

5. Weight ratio of mixed binding mortar is water: mortar =1:5, mixing while adding water;The stirring time should not be less than 5min. The stirring must be sufficient, uniform, with moderate consistency and constant viscosity.

6. After the mortar is modulated, it shall be set for 5 minutes, and then stirred again before use. The mixed mortar shall be used up within 1 hour.

7. In order to enhance the binding force between the extruded board and the binding mortar, the ceramic fiber board shall be pasted before.